Over 500 Options. Wall-Mounting, Water-Tight, Colors

One of the most popular small enclosures sellers is Hammond Manufacturing's 1590 Series Diecast Aluminum Enclosures. These rugged electronic instrument enclosures are tough yet easy to machine.

Features

Rugged, diecast aluminum alloy (tough - yet easy to machine), electronic instrument enclosure.
Lap joint construction provides protection against access of dust and splashing water. Also provides for improved EMI/RFI shielding.
Unpainted version is vibra finished for a smooth surface with no sharp edges.
Satin black painted version is painted with tough polyester powder paint for a lasting finish, even after machining. Black screws are included to enhance appearance.
Includes screws thread into factory-tapped holes. Screw type and quantity vary.
Standard versions are designed to meet IP54.
Water-tight versions are designed to meet IP65.
Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.

Hardware

NOTE: 1590 series enclosure feature factory-tapped assembly screw holes that accept machine screws, which are included with the enclosures. Most sizes require four (4) screws. 1590BX, 1590BX2, 1590D, 1590DD, 1590DE, 1590E, 1590EE & 1590R1 require six (6). 1590F requires eight (8).

Tamper-proof Hardware Upgrade (Torx w/ Pin)	Replacement Hardware

Gaskets

NOTE: Gaskets are included with watertight 1590 enclosures. They can also be purchased as a kit if you'd like to upgrade an IP54 enclosure to IP65.

Each kit includes two pre-formed silicone gaskets.
Gaskets include adhesive backing for easy installation.
Allows enclosure to be machined and/or painted first and gasketed later.
Gasket is applied to the lid.
Designed to meet IP65 with properly installed gasket and lid screws torqued to 25-30 cN.m (36-43 ozf.in).
Refer to part number table below for correct gasket.